Turbines » Jetcat Turbines » JC80

JetCat P80-SE Turbine


Introducing the new JetCat P80-SE with more POWER and enhanced reliability.

The P80-SE continues our extremely successful P80 engine. The new design of the P80-SE incorporates an optimized compressor/diffusor-system, resulting in higher engine performance and reliability.

The engine follows throttle commands almost without delay.In addition to the outstanding features of or ECU V6.0, the new ECU V6.3 has an auto power down function built in, which allows to switch off the engine power supply (--> receiver off) before the engine cool down sequence has been finished. In this case the ECU will stay powered on, finish the cool down sequence and then auto power down itself.

JetCat P-80-SE turbine complete with starter includes:

  • Jet-tronic ECU (fuel control electronics)
  • GSU (Display and Programmer)
  • LED I/O board
  • Miniature fuel pump
  • Electronic starting gas valve
  • Electronic Fuel valve
  • Fuel tubing, tubing connector set, filters, and cable set
  • 2 cell, 2500mA LiPoly battery pack
  • Starting gas tank
  • Turbine mounting clamp, RamTec compatible
  • Detailed instruction manual
Thrust: 22 LB @ 125,000 RPM
Weight: 2.9 LB, incl. starter
Diameter: 4.4 inches
RPM Range: 35,000 - 125,000
Exhaust gas temp.: 580C -690C
Fuel consumption: 9 oz per/min at full power
Fuel: Jet A1, 1-K kerosene
Lubrication: approximately 5% synthetic turbine oil in the fuel
Maintenance interval: 25 hours

P80-SE Thrust Chart
RPM Thrust
35,000 0.8
85,000 8.0
93,000 10.0
101,000 12.5
110,000 15.0
117,000 17.0
118,000 18.0
120,000 20.0
125,000 22.00

Returns   Privacy Policy

Copyright © 2018 Cozmik Toys